Why is my engine light on after service?

You may think that there is still a problem with the car after the repair, but it’s because the light needs time to reset. The car’s internal computer only resets after a set period where it checks all of its sensors once more. The reset can happen automatically after around 10 to 20 cycles.

Why is my check engine light on after a service?

This means that more than one problem could be causing your check engine light to illuminate. Perhaps the technician replaced your oxygen sensor, but your engine also needs some spark plugs to be replaced. The best course of action here is to take your car to the technician again to see what else needs to be done.

Does check engine light need to be reset after repair?

Your car’s check engine light will reset itself after you repair the problem in most car models. … A car usually needs 10-20 successful cycles before it will reset the check engine light by itself. A cycle is when you start your car cold and drive it until it is warm and then until you are done with your driving.

INTERESTING:  How do you rejuvenate a dead car battery?

What is the most common reason for check engine light?

Replacing a faulty oxygen sensor — a sensor used to optimize a vehicle’s fuel-to-air mixture to increase gas mileage and reduce emissions — is the most common cause for a check engine light.

Why is my engine light on but nothing seems wrong?

Normally, the appearance of a check engine light indicates a problem somewhere in your vehicle, but nothing seems amiss. … The problem can even be as simple as forgetting to tighten your gas cap – in fact, this is the most common reason why check engine lights appear in the first place.

Is it OK to drive with check engine light on?

The rule of thumb is that if the check engine light is flashing, you can’t keep driving the car. It’s an emergency. Often it indicates an engine misfire. If you keep driving, you will likely cause irreversible damage, mostly to the (expensive) catalytic converter.

Can Autozone clear engine codes?

Yes they can make the light go out temporarily. They do it by using a scanner to erase the readiness monitors. Then until the readiness monitors reset (might be days, weeks or months) the light will stay off. That is, unless there is a hard failure then the light will come back when the car is restarted.

How long do you have to drive to reset engine light?

To make sure the check engine light does not reappear, it’s recommended that you drive your car 30 to 100 miles. This enables the vehicle’s “Drive Cycle” to reset, as the various sensors need time to recalibrate.

INTERESTING:  Best answer: How much should a windshield cost?

How long does it take for a car computer to reset itself?

The readiness monitors will remain until the car has been driven long enough for the computer to evaluate the various system and sensors. The amount of time can vary based on the vehicle. In some cases it can take up to 100 miles for all of the computer monitors to completely reset.

What does a solid check engine light mean?

A solid Check Engine Light can mean something like a loose gas cap, or it can indicate a more in-depth problem like a fuel, timing, or transmission issue. Get your car diagnosed, although the urgency isn’t the same as if the light was flashing at you.

Can AutoZone check engine light?

Does AutoZone Scan Check Engine Lights? AutoZone does. If your light is on, and you are wondering why, head down to your local AutoZone where one of our store associates can help diagnose the issue through our free Fix Finder service.