How do I get a dent out of my bumper?

If the dent is on the plastic bumper (or another area of your car made of plastic), applying boiling water to the blemished area should take the dent right out. Boil a pot of water and pour it on the area with the dent, and then reach behind the bumper and push until the dent pops out.

How can I remove dents from my car at home?

Here are five quick and easy ways to remove minor damage from your vehicle’s exterior so that you can once again smile when you look at your car.

  1. Try the plunger method. …
  2. Use hot water for dented bumpers. …
  3. Hammer out the dent. …
  4. Pop out the dent with a hair dryer and compressed air. …
  5. Buy a dent removal kit.

Can you fix a dented bumper?

If they are small in size and confined to one area, these dents can usually be repaired. It’s important that the dent did not result in damage to other portions of the bumper. Auto shops that offer dent repair in Salt Lake City can pull out the dent and repair any paint damage.

Does pop a dent work?

It doesn’t magically remove all dents, but it does make certain dents look better. I would say the best type of dents that it works on are crease type dents or uniform medium sized dents. It does not work well for small door dings.

INTERESTING:  How long do Volvo engines last?

How do you get dents out of metal fenders?

Use a hairdryer or a heat gun to heat up the dented area. Then, freeze it with compressed air. As heat expands the body panel, cold will shrink it, pulling the dent out. This works best on shallow dents in plastic body panels but may work on metal panels.

Does boiling water remove dents in metal?

Before applying tools, try the following: wash the dented surface with hot, possibly boiling water. With a bit of luck the metal will flex and pop back in its original form. … The hot water always supplies sufficient heat to make the paint and the material smooth.

Can you fix a car dent with hot water?

Not quite! Here’s a few reason why this is risky to try: You have a high risk of burning your fingers before you are able to successfully pop the dent back into place. Using boiling water on the car part is just as likely to cause further damage, which will only increase the cost of repair.

How much does it cost to fix dent in front bumper?

If you just need to have the dent pulled back out and into place, the repair will likely cost $50-$100. However, if the dent is very deep and the paint was damaged as well, you could be looking at a repair of around $200-$1,000, depending on the dent and your chosen repair shop.